Also ich check immer noch nicht, wie ich den Teller entfernen kann...denn das muss ich, ansonsten müsste ich den Riemen durchschneiden, um den austauschen zu können, denn der hat sich irgendwo verhakt und lässt sich beim besten Willen nicht mehr in die gewünschte Position (siehe Abbilung/Bescheibung) bringen..
wenn du den riemen durchschneidest, bekommst du den neuen folglich ja auch nicht drauf.
Google sagt folgendes:
1, Remove the rubber platter mat to expose the platter.
2. Put your thumb and forefinger through the two round holes and lift the platter off. You may need to give the centre spindle a light tap (whilst applying upward pressure) with a screwdriver handle or some similar tool that will not leave any marks or damage.
3. Remove the old belt and wipe the platter pulley and motor pulley with an alcohol swab to remove any old belt residue.
4. Place the new belt around the platter pulley making sure t is sitting flat without any twists.
5. Flip platter over the right way up. There are1or 2 larger rectangle shaped cut outs in the platter.
6. Through the cut out pinch up the belt and slip a finger or belt hook between the platter pulley and the belt gripping the belt ready to fit over the motor pulley.
7. Align the centre hole of the platter with the spindle and place platter back into position keeping a grip on the belt.
8. Slip belt over motor pulley and give the platter a light clockwise rotation to ensure the belt is riding correctly.
9. Replace the rubber mat and then run the turntable to ensure correct operation.
http://www.fixya.com/support/t1166341-turntable_belt
ich vermute du hängst an punkt 2 fest und bekommst den teller nicht runter.